Does This Non Aluminum VC Support look Out-of-Round?

**417 - Alnico** · May 31st, 2012, 11:30 PM

Altec Lansing N.O.S. cone assembly for 417 series (12" / 8 ohm) | eBay

**Altec Best** · June 1st, 2012, 12:29 AM

It could be the angle of the snapshot. If Picture was taken directly overhead I think you would have a better idea.Impossible to tell from that angle IMHO.

**cradeldorf** · June 1st, 2012, 12:29 AM

Out of round or tapered? My camera does that when you shoot up close. distorts the view. I'd bet the VC is fine and it's just the camera angle.

**417 - Alnico** · June 1st, 2012, 05:18 PM

I understand. Looking at it as a clock...at about 4 the surroung looks a bit bowed
out. Any way thanks for the replies. Must be s C or earlier due to I think D's... and know H's have a Alum support.